ABSTRACT:
The main objective of this paper is to enhance the power transfer
capability of grid interfaced hybrid generation system. Generally, this hybrid
system is a combination of solar and wind energy systems. In order to get
maximum and constant output power from these renewable energy systems at any
instant of time, this paper proposes the concept of maximum power tracking
techniques. The main concept of this maximum power point tracking controller is
used for controlling the Direct Current (DC) to DC boost converter. Finally,
the performance of this Maximum Power Point Tracking (MPPT) based Hybrid system
is observed by simulating using Matlab/Simulink.
KEYWORDS: MPPT Technique, Solar
Energy System, Wind Turbine System
SOFTWARE: MATLAB/SIMULINK
BLOCK DIAGRAM:
Figure 1. Configuration of Hybrid
Energy System.
EXPECTED SIMULATION RESULTS:
Figure 2. Simulation Diagram for
Hybrid Wind-PV System.
Figure 3. Output Load Voltage.
Figure 4. Output Load Current.
Figure 5. Powers: Line, Wind,
Solar.
Figure 6. Output Voltage from
Wind System.
Figure 7. Output Voltage from
Wind System.
CONCLUSION:
Output from solar and a wind system is converted into AC power
output by using inverter. In the given time additional load of 5 KW is
connected by using Circuit Breaker. Under all operating conditions to meet the
load the hybrid system is controlled to give maximum output power. Battery is
supporting to wind or solar system to meet the load and Also, simultaneous
operation for the same load.
REFERENCES:
1. Huil J, Bakhshai A, Jain
PK. A hybrid wind-solar energy system: A new rectifier stage topology. 2010
25th Annual IEEE Proceedings of Applied Power Electronics Conference and
Exposition (APEC); 2010 Feb 21–25. p. 156–61.
2. Kim SK, Jeon JH, Cho CH,
Ahn JB, Kwon SH. Dynamic modeling and control of a grid-connected hybrid generation
system with versatile power transfer. IEEE Transactions on Industrial
Electronics. 2008 Apr; 55(4):1677–88.
3. Ezhilarasan S, Palanivel P, Sambath S. Design and development
of energy management system for DG source allocation in a micro grid with
energy storage system. Indian Journal of Science and Technology. 2015 Jun;
8(13):58252.
4. Patel MR. Wind and solar
power systems design analysis and operation. 2nd ed. Taylor and Francis Group
Publishing Co. 2006; 30(3):265–6.
5. Chen YM, Liu YC, Hung SC, Cheng CS. Multi-input inverter for
grid-connected hybrid PV/wind power system. IEEE Transactions on Power
Electronics. 2007 May; 22(3):1070–7.